December 7, 2024
Description
A handy dandy little drawer that can be mounted under most desks with screws or double sided tape.
Recommended orientation for strength is to print the basket bottom side down on the buildplate to avoid any problems with layer adhesion if dropped or when removing supports.
Can also be printed upright with PETG or PLA with supports for the front facia of drawer.
The rails can be printed without supports upright.
Any layer-height will do with or without input-shaping. Tested with Ikea Fredde table
*11.2.2024: Added a deeper variant with 13mm of extra space
*7.12.2024: Added more info about printing orientation
License:
Creative Commons — Attribution — Noncommercial — Share Alike
9
SynthWave00
