Aerodinght - The Witcher's Silver Sword

Model is based on this model from Sketchfab, and has been edited, and adapted for 3d printing by me- "Aerondight - The Witcher" (https://skfb.ly/onVn8) by Aren Boada is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).

The sword is around 120 centimeters (1,2 meters) long. 
There is a 5mm (5.4mm to be exact) hole going through all the parts, you can join them with the pin included with the sword, although I strongly recommend to put a metal rod inside the sword to add extra rigidity to it.

Most of the parts have been split for easier printing, though if you want to print the full parts, I have also included these.

If printing the full sized parts you're gonna need one of each parts included in that folder.

If printing the split version you're gonna need one of each parts included in the folder, except for the crossguard, which you need two pieces of.

The crossguard has a rectangular hole on the upside, where the blade should slide in freely (tested with the split version only, if it's too tight then you might just need to sand the blade's bottom walls a bit)