Raptor / Paptor H650 FPV Camera Mount

Xiaxiu Raptor / "Paptor" H650 removable mount for all-in-one analog FPV cameras.

Made for the Wolfwhoop WT03 all-in-one camera, but may fit other camera models. You can buy one here: https://www.amazon.com/Wolfwhoop-Adjustable-Transmitter-Cloverleaf-Aircraft/dp/B06XB2ZRBP?ref_=ast_sto_dp 

There are two mount options:

1. Standard version: has a built in slot and threaded portion that allows it to be attached to the the plane's canopy using the included washer and wing nut. You can easily remove the mount when not in use.
    
2. No screw version allow you to glue or tape the mount in place.

This camera runs off 3-5v, so you can attach one end of the included removable plug to a 5v source on the plane's receiver. You can also power it with a separate 1 cell battery if desired.

The mounting position places the camera close to the plane's center of gravity and keeps some of the nose in view for reference when landing the plane.

Print Settings

I recommend printing out of PETG to handle the heat of the video transmitter.

I used 0.12mm layer height for the threaded portion of the model and then 0.2 mm for the rest of the model. This can be set in your slicer with a settings change at 8mm layer height. Or just print at 0.12mm for the whole part.

For the Washer and Nut, I printed at 0.12mm layer height.

For the mount, turn on supports (I chose Normal “Snug” supports) and print in this orientation

There should be no support on the threads, just the area around them.