Cricut Accessory Holder

My wife loves her CricutMaker and has a bunch of different heads/accessories, so I designed and 3D printed a custom accessory holder, specific to her setup. Holds six cricut accessory heads, plus some of the new #QuickSwap heads.

I've uploaded design files for her design, plus a single accessory holder for folks to use as a building block for their own holders.

The design is very simple to print -- if printed bottom-side down, any resolution should work with no rafts or supports, with whatever infill you'd like.

Print Settings

Printer Brand:

Ultimaker

Printer: 

Ultimaker 3

Rafts:

No

Supports: 

No

Resolution:

0.2 mm

Infill: 

20%

Filament: any Any

How I Designed This

Designed in Fusion360. Prototyped surprisingly quickly with an Ultimaker3 and its 0.8mm print core, and the quality was good enough that I didn’t need to reprint at higher resolution, even though it would look better printed with the 0.4mm head.

I printed mine with 0.2mm resolution (again, with the 0.8mm head).