Anti-droop detented arms for Modular Mounting System

These are anti-droop arms for the Modular Mounting System. For full documentation, knobs, and other parts, please refer to the original model.

The joints in the original design are held purely through friction, which means they droop easily due to gravity depending on the load. This remix adds detents to the joints to prevent drooping. It snaps to intervals of 45 degrees.

To generate custom sizes or export as STEP, use this Onshape document.

Note: The 3-pronged side has the center prong slightly thinner than the original design. This is intentional, to leave a small gap to allow the mating prongs to flex as they travel between snapping points.

Tested with PLA.