February 14, 2024
Description
Got tired of dirt getting everywhere at the rear of the bike, so here is a little fender for that.
Printed from pla at 30% infill with 3 perimeters it seems to hold up just fine.
Mount with 3x zip-Ties with up to 5mm width and you are good to go. The side with the small lip has to points upwards.
The first version(the one in the thumbnail) fit a little bit too tight between the seatstays, so on v2 I adjusted the fit a little bit and also removed the stiffening rib since it seems to be stiff enough without it.
Since I haven't printed this updated version yet, this is marked as work in progress.
It's possible that this could fit on the 2023 JAM² as well, but I'm not sure.
Have fun!
Imported from my thingiverse account
License:
Creative Commons — Attribution — Share Alike
11
thefuckwhatever
