NR200 ATX PSU Side Mount

Edit: A new version moves the PSU up an additional 5mm inside the case. Depending on your PSU, the power cord might interfere with the top panel.

A custom designed remake of the ATX PSU bracket for the NR200 and NR200P that relocates it to the original side PSU position to allow for the use of the side panel bracket for fans, a radiator, or HDDs.

Features a very breathable face to allow for PSUs to be mounted with their fans towards the right side of the case and still get sufficient airflow through the side panel.

Designed to work with standard (included) #6-32 case screws.

Note: If you want to use this with a full length GPU, you may run into some trouble with clearance for your PSU wires. ATX PSUs range in length up to 160mm, and mine is the full 160mm. It is also only semi-modular as it is an older unit. Looking at the last picture (looking from the bottom towards the top of the case), you can see that the modular cables coming out of my PSU just barely fit past the side of the GPU. 140mm PSUs should fit just fine with any GPU as long as the cables are not too stiff.

Notes:

Recommended to print upside-down with the PSU mount down on the bed (same orientation as the Cooler Master provided bracket). No supports should be required, may require some printer tuning to get god bridging.

I printed mine in PLA with 50% triangular infill (sliced in Cura) and am satisfied with it's strength. ATX PSUs can be quite heavy though, so I would not recommend this bracket if you frequently move your computer around.

The mounting screw holes are designed to take a standard #6-32 case screw directly into the plastic. I recommend heating the screw up and slowly threading it in to prevent the model from splitting.

Category: Computer