February 15, 2024
Description
Support for Z3 Thayer Seat Tilt Kit. low cost kit i found on amazon focuses force onto a small point on the cars floor that i am concerned will break due to fatigue stress over time.
utilizes all components from the Kit. install small washer, standoff, and stud as instructed then slide the printed part over before the 2 washers between the standoff and seat.
Print with ABS(material most plastic parts in car are made of), ASA (recommended), or PETG. use a infill strong in Z, in Cura i used Grid.
DO NOT USE PLA; it can soften and will not provide any support especially if living in a warm place.
will probably fit most seat tilt kits similar to this one i used:
https://www.amazon.com/dp/B01N7X0YZS
License:
Creative Commons — Attribution — Noncommercial — Share Alike
10
LvL_Dani
