Keyrack motorcycle, home, bicycle, car

When i was looking for a fitting key holder for various keychains of mine, none were eaxactly what i was looking for.

I remixed a few Printables with their shapes and designed a backboard with custom key hooks, which resulted in this upload!

This design is made with 3 hooks, but can easily be self changed since i did add the key hooks in the files, put a flat plate (3mm thick in this design) in your editor/slicer and put these key hooks in them (70mm apart from each other in this design).

I've added some extra remixes in the files from some other logo's/pictograms, just glue them in place which one you like. Tip: for smoothest result, glue the models with the printbed-side UP, so the evenly textured/smooth surface of it will face you when looking at the keyrack!

Don't make the same mistake i did by putting too few solid top layers at the keyrack, which the result is to be seen in the photo's ;)

Recommanded print settings for the backboard+hooks:
- 0.6/8mm nozzle (structural purpuse).
- 3 or more perimeters.
- 4or5 top and 3 bottom solid layers (large area's tend to slack and make the infill visible).
- 20% gyroid infill.
- 0.40mm "Draft" layer height, since this is a structural part, no need for it being nice.
- Supports: Off.
- Every other setting is the stock Prusament PETG setting in 0.6mm or 0.8mm nozzle configs.

Recommanded print settings for the models:
- 0.25mm nozzle.
- 3 perimeters.
- 3 top and 3 bottom solid layers.
- 15% gyroid infill
- 0.12mm ""Structural" layer height.
- Supports: Off.
- Every other setting is the stock Prusament PETG setting in 0.25mm nozzle config.