Sample Spool Holder Arm (Tall Remix)

This is a remix of the Filament Sample Spool Holder by FilamentColors.xyz . I am using this mount on my Prusa Mini to attach the to the vertical rail.

I installed the Filament Runout Sensor Holder (www.thingiverse.com/thing:4582929) but soon found that this made the sample spool holder un-usable because the sensor now interfered with its rotation. So I remixed the holder arm to make it tall enough to clear the addon run-out sensor holder arm. I had to make to 10mm thick, which seems like overkill, but the prototype was 4mm thick and it broke off when the filament had a small snag because the layers ran horizontally causing it to be too weak.

Print Settings

Rafts: No

Supports:  Yes

Resolution: 200

Infill: 25

Filament: PLA

Notes: 

Print upside-down with support for the curve

You'll also need:
Mount (original) www.thingiverse.com/thing:3250547
or Mount (my offset remix) www.thingiverse.com/thing:4899134
2x M5x10 cap head screws
2x M5 3030 T-nuts or printable: www.thingiverse.com/thing:3663001
Expandable Filament Sample Spool Holder: www.prusaprinters.org/prints/36621-expandable-sample-spool-holder