Filler - Sample Spool Brace for 3030 Profile (Offset Remix)

This is a simple remix of kino90's Filler - Brace for 2020 profile. I had to remix it because I printed cable chains to use on my Prusa Mini, but found that the mount would interfere with the path of the X-axis chain near the top. To solve this, I just offset the mount 6mm to the right, so that the left edge is even with the front edge of the rail.

I am using this mount on my Prusa Mini to attach the Filament Sample Spool Holder by FilamentColors.xyz (www.prusaprinters.org/prints/38041-prusa-mini-sample-spool-holder) to the vertical 3030 rail. I also remixed that holder to make it tall enough to clear the addon run-out sensor holder arm.

Print Settings

Rafts: No

Supports: Yes

Resolution: 200

Infill: 20

Filament: PLA 
 

You'll also need:

• 2x M5x10 cap head screws
• 2x M5 3030 T-nuts or printable: www.thingiverse.com/thing:3663001
• Expandable Filament Sample Spool: www.prusaprinters.org/prints/36621-expandable-sample-spool-holder
• Sample Spool Holder Arm original: www.prusaprinters.org/prints/38041-prusa-mini-sample-spool-holder
• or my Tall Remix: www.thingiverse.com/thing:4899152