Neutrik NA enclosure mount for K&M Microphone Stand Boom Arm

I needed a microphone stand mounted inline switch for a microphone.  I built it into a Neutrik NA extruded aluminum enclosure (it's also available printable).   This print surrounds the outside of the aluminum housing.   The lower half takes a bit of effort to snap in.  4x 4-40 screws go through the Neutrik D-Series connectors, through the print, into the extruded aluminum.   I included 8 holes in the print, but only two per side are required.    
 
There are spots for up to 10x 10mm x 1.75mm magnets if you want it extra secure.  You could also just wrap some gaff tape around it.  :)