Arturia MiniFreak Stand/Feet

Simple clip-on feet/stand for the Arturia MiniFreak synthesizer that angle the device slightly, so that the display and labels are easier to read. The printed parts can quickly be attached and removed again. Multiple versions are available that differ in angle and height. The normal version only tilts the MiniFreak. The raised versions provide roughly 4.0 cm of clearance so that keyboards and other smaller devices fit under it. The angle defines how far the back of the unit is raised compared to the front:

• 8° = 3.2 cm
• 10° = 4.0 cm
• 12° = 4.8 cm
• 15° = 6.0 cm

Print the left and right foot in the provided orientation with PLA. The following settings turned out fine for me:

• Nozzle: 0.4 mm
• Layer Height: 0,2 mm
• Walls/Perimeters: 3
• Top/Bottom Layers: 4
• Infill: 10%
• Support: No
• Brim: No

I added some rubber feet to the bottom of both parts to make sure the device doesn't move or scratch the table.