Cigarette case - Ace of hearts (no support)

A small rugged case for a few cigarettes so you can bring them with you and not carry a whole pack. 

Make:

To make the magnetic case simply print the magnetic_lower and magnetic_top files and add 4 magnets. The holes are 6mm in diameter and 5mm deep so chose magnets accordingly. They were fine just press-fited in my case but you might need a little bit of glue to make them stay. The 4 magnets hold it tight enough for any application. 

To make the hinged case print the files hinge_lower and hinge_top, add 2 magnets into the holes (the same as in the magnetic assembly) and add a hinge bolt. I don't know what bolt exactly but the length of the hinge is 46mm and the hole is 3mm in diameter. (Let me know what bolt works if you try it - thanks) 

I printed no support and PLA on a bambu P1P using black bambu PLA and worked fine. 

Leave any comments or photos of your prints. Good luck ;-)