Luxurious concrete wall lamp

I designed this mold for casting a 10 by 10 cm and 20 cm high wallmounted contrete lamp.
I added a version for reusing the casing and a version for onetime use only.

To be honest, I never tried the reusable one, so if it sucks or doesn't work, please give me a review!

To mount the two GU10 Lamps inside, you have to buy GU10 Sockets from your local hardware store or shop them online, they're quite cheap.
I added HUE Bulbs to my lamps at home so I can adjust the brightness, very handy at night.

I used floor screed concrete 0/16 mm if I recall it correctly. Just fill the casing up, make sure to wiggle and knock out all air and you should be good to go.

Things to print:

• One version of the casing , reusable or not
• Carrierring
• GU10_Double_holder (use a lot of support and a upper vertical seperation layer)

GU10_Holderclip Assembly should be self explanatory.

If you want to spend me a coffe www.paypal.me/quintz

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3

Rafts:

No

Supports: 

Yes

Resolution:

0,4

Infill: 

20

Filament:

Formfutura PLA Grey 
 

Notes: 

Use a lot of support and a upper vertical seperation layer on the GU10\_Double\_Holder

Category: Decor