Food can FIFO dispenser

You need to rotate your food cans (use the old ones first). This dispenser lest you always grab the oldest one first and top your stock up from the front. It does not need to be a prepper thing, because in general you are better off if you make sure to use the oldest ingredients in the kitchen first.

I have seen a lot of dispensers, but way too many just for soda- and beer cans. This is a relative simple print and assembly. No extra slicing expertise required. Just glue the two halves together.

Two sizes

34 cm depth

• Stores 8 food cans (Ø=75mm, height=110mm)
• Can sit on 30cm shelve or deeper
• FIFO dispensing (first in, first out)
• Low model profile for easy shelf fit

25 cm depth

• Stores 6 food cans (Ø=75mm, height=110mm)
• Can sit on 25cm shelve or deeper
• FIFO dispensing (first in, first out)
• Low model profile for easy shelf fit

Printing

Print two pegs and just print them lying down, without supports. The holes are a bit bigger.

While printer settings are not that important for this model, here is my settings:

• Infill 5%
• 3 outer walls
• 0.2 layer height
• No supports

Please like it - if you like it

Your feedback is my reward. Please give me a like if you enjoy this design.

Happy printing!

2024-04-01 UPDATE.

New sliced 34cm version printable on a 190x121 mm bed