Silvercrest dehydrator extension VaseMode for spools (+ optional plate)

Here is a cover for the Silvercrest's SDA 350 A2 dehydrator to put 2 filament spools in it.

The main différence compared to existing model is that this one can be print fast in one single part in spiral-vase mode (on a 350+ bed). It can be use with or without a bottom plate.

You can easily reduce or increase the high if you want to put only one spool or more than one by change the Z scale in the slicer (but higher cover will be less rigid).

There is also a plate model if you don't want to use the original one and keep it to use with food. The design is very close to the original one only for aesthetics reasons. If you're not interested in this aspect, I'd advise you to modify the model for shapes that are quicker to print. If the tray is too wide to fit over the dehydrator, simply sand the shoulder slightly.

Printing recommendations:

Cover

• Material: ABS
• Spiral vase mode
• Layer high: 0,28 mm or more if you can
• Layer width: 0,7 mm or more if you can
• Bottom shell layers: 4

Plate

• Material: ABS
• Layer high: 0,2 mm or more
• Infill: 20% or more (grid,rectilinear, gyroid)