QFH Antenna 419Mhz(433Mhz Band) 2-Parts

419mhz Center Freq. Hope the bandwidth is good. This was model 100% to a the calculations of online calculations to the 0.5mm. Going to be intresting to see calculation vs result. I suspect the plastic will have effect but since center is 419mhz should not be to bad.

This should make it easy for anyone to even make it out of twinflex stranded copper.

NOTE: The print was broken into two parts to help print in sections,

Print Top section Right side up..

Print Bottom Section Upside down

https://www.youtube.com/channel/UCOF4Weyd86jnmXrSXUu6xHg https://www.youtube.com/channel/UCx3vuuvTi2mlCWkdZUr-bow

Print Settings

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2

Infill:

Filament: WhoCares PLA

Notes:

Category: Electronics