General simple door handle - with screw cover

This handle was designed with the following goals:

• Replacement for (what appears to be) generic outer glass-door handle (here in Germany)
• Distance between screw holes: 48mm
• Print in place without supports

It should be ok to use as a generic handle for doors/windows.

Print Settings

I used 15% infill and two walls, but if you want a sturdier handle, you could go all the way to 100% (as it is rather small so would not use much filament).

It prints without support with the model laying on the mostly flat side (as is, when the model opens). But this needs a well tuned printer, so the overhang section is not too untidy.

The screw cover I printed on its side (as is, when the model opens) so that the filament layers make the part more flexible. What I mean is that while you could print it flat on its back, then all you are counting on for the part to be flexible when it snaps on is the adhesion between layers, which I didn't want to depend on.