March 7, 2024
Description
A simple and quick remix of my 'Bumper Case' for the Badgy, by sqfmi. The Badgy is an ESP8266 2.9" e-paper module, available on Tindie https://www.tindie.com/products/squarofumi/badgy-iot-badge/.
This is a remix of the badge bumper lanyard case and is designed so you can clip the Badgy in and sit it on a shelf, desk, table etc and it will stand up. I wanted the use the weather app on the Badgy and couldn't stand it up anywhere... problem solved!
Printer:
P3Steel Toolson Ed
Rafts:
No
Supports:
Yes
Resolution:
0.15mm
Infill:
100%
Filament: Any PLA
Any
Notes:
Best to stick to 100% infill, it's only small and you'll be done in a jiffy! You MUST enable supports as there are overhangs that will not print without them. Print it face down on the bed.
There are four little lips on the corners. The Badgy can just be pushed in and stays in with friction.
Category: ElectronicsLicense:
Creative Commons — Attribution — Noncommercial
8
ChunkySteveo
