Step Ladder Handle ( Polder LDR-90401-87 )

This is a replacement handle for the

Polder ladder 
LDR-90401-87

It may work for other ladders if they have two holds  130.6mm apart and each hole is 14.7 mm wide and 5.6mm tall. 

The ladder is meant to be about a 10mm wider than it should be, so it will take some force to get it to go in, but human force is enough.  The goal is to provide enough pressure so the tabs hold the handle. 

The test and final piece was printed in PLA with .4 mm nozzle, 3 perimeters and 15% infill in grid pattern.  tabs and their surrounding material were printed with 40%infill and triangle pattern for added strength.  Feel free to print it in PETG if you plan to store the ladder in the garage, but this one is stored by the kitchen. 

Attached are:

• A picture of the modifiers in Prusa Slicer.
• Rough measurements so you can measure before you print.
• A picture of the ladder since this is a very specific make that is probably useless for any other purpose without heavy modification.