REVO Prusa Mini Dual 4010 Part Cooling Fans (Adapted from Annex K3)

Add dual 4010 fans to a Prusa Mini with a REVO hotend.  Uses Annex Engineering K3 4010 fan ducts, at original angles and spacing. 

Suggested Fans:  BFB0405HHA-A (2 wire, no Tach) or BFB0405HHA-AF00 (3 wire, w/ Tach)

If you want the fans to report RPM you will only use one Tach signal, so you could get one of each fan type or 2x 3 wire fans and leave one Tach wire disconnected.

The ducts hang pretty low (~2mm above the build sheet), so you will need an ultralow profile heater cover like this one I made. => https://www.printables.com/model/815865-prusa-mini-ultra-low-profile-bed-heater-cover-16mm

You will need to shave the build plate alignment pins too.  I put M3 nuts (~2mm thick) on the alignment pins as spacers then cut the studs flush to the nuts with a dremel cutoff wheel.  

Hotend nozzle and pinda probe maintain their original positions. 

Hardware needed: 4x M2x8 screws, 4x M2x14 screws, 5x M3x8 screws, 1x M3x 10, 1x M3x25 screw, 7x M3x5x4 heatset inserts and reuse OEM hardware for the rest.

I recommend to print the parts in ASA, ABS, or PC.  PETG is OK too if you do not intent to place your printer inside an enclosure.  PLA should only be used for a mockup.

* This design is a work in progress so please share your change requests and I will try to integrate them. 

05/04/2024 - Replaced corrupted E3d REVO adapter.stl with slicer tested E3d REVO adapter_r01.stl