Stealth Press (Adapted to 2020 Extrusion)

I had a lot of spare parts after converting my Ender 3 to a Switchwire, including a linear rail that was 20mm too long for the orignal Stealth Press. So I decided to just adapt the existing files to my spare 2020 aluminum extrusion that served as the original x axis on the ender 3. 

The legs attach using 2 m5x10 screws and t-nuts on each side. Same for the top piece, but I only used one in the lower position and one in the higher on the alt side. So, need at least 6 m5x10 screws and m5 T-nuts for the printed parts + whatever screws and nuts needed to attach your linear rail.

The rest of the pieces I used the original files, and attached to the extrusion using m3 screws and t-nuts. Including the not a keybak mount.

Additionally, I had F623rs from the ender 3 belted z mod, So I adapted the pulley spacer model to fit these and adapted the Stealth Press top piece to use m3 screws to fit. I have included a top piece retaining the orignal holes for m5 screws.

(also I used this model for the soldering iron mount since I had an mgn9, Thanks @JWhite!)

Thanks to @IconicFAB and @suyash_601871