Mini 12864 Pivoting Display Top Frame Mount for 3030 Extrusion
boothyboothyMarch 14, 2024
Description
A Mini 12864 pivoting display Mount for a Vevo or other 3030 based 3D Printer with fixed ratchet positions from 0 to 80 degrees.
The Rear Housing & Display Mount are modified parts based on the Voron Design V2.4 display mount. So full credit & attribution to Voron Design team regards these specific parts.
Mini 126864 display Here:
BIGTREETECH MINI12864 V2.0 LCD Screen VORON 2.4 RGB Backlight Mini Dis – Biqu Equipment
You may need longer ribbon cables dependent on the size of your printer. For my Vevo (Voron 2.4 conversion) I have used 1000 mm cables:
Installation
I have removed a small section of insulation tape immediately behind the display to feed the ribbon cables below the acrylic top panel. The ribbon cables are fed vertically down the adjacent 3030 post. They are dressed to the deck panel with a custom z cover plate (see uploaded images).
Please note that depending on the manufacturer the display aperture position can vary a little. I have adjusted the display aperture by a 1.5 mm offset to make things align correctly. You may need to adjust this via the step file for personal use. A draft test prior to final production is recommended.
BOM
IN addition to any extended ribbon cables, you will need:
4 x M3 Heat Sets for the display frame fixing.
2 x M3 Nylocs for the Circular nut housings.
2 x M3 x 10 mm bolts to fix the side cheeks to the frame.
4 x M3 x 16 mm bolts to fix the Rear Housing to the display Mount
2 x 14 - 16 mm bolts to fix the circular nuts within the ratchet assembly
Printing
The Display mount includes a small bridging helper\support that will require removing prior to assembly.
Suggest printing parts in the orientation uploaded
Printed with Hatchbox Silver ABS:
& Cat Yarn Cheshire Purple:
Cat Yarn Cheshire Purple - PrintyPlease.uk
Vevo - HEVO to Voron 2.4 conversion here:
