Hex Bit Holder for Rugged Box V2.0

I made this model, but it is specifically made for Whity's Rugged Box V2.
Its made for the standard size of the rugged box v2.0 (inner dimensions 120 x 70 x 30).

The real inner dimensions of the box that resulted in my print is 119,80 x 69,70 x 29,80.
My bit holder is made to fit in my box.

printed:
- in PLA
- 0,3 mm layer height
- 2 walls
- 10% cubic infill 
- with the holes facing down
- no supports needed

The pictures do not show the version you can download here. It is version 1 of my design.

The differences are:
- increased hole size for the bits from 7,4 to 7,5 mm >> the bits where a little too tight-fitting, now they are more loose
- reduced the number of bits to 45 (9x5) with a spacing 12 mm >> even with small fingers it was inconvenient to take out the bits
- removed the protrusion on the sides >> the hole holder was a nearly stuck in the box, and I could remove it only with the help of a tool and some almost destructive force.

I didn't print this version here, because I keep version 1 for now.
Feedback is appreciated if something doesn't fit.

Happy Printing!