CR Touch Zero Y Offset with Inserts and more screw space.

Most of the information about the printer setup can be found on the original model page:

https://www.printables.com/model/438224-x45-sprite-cr-touch-probe-zero-y-offset-mount-v11-

Not every hole should have a threaded insert. Only the CR Touch holder and the ribbon holder have the correct sizes. I included the step file, so feel free to adjust it to your liking.

What you need for this model:

• M3 inserts, 5.7mm x 4.6mm, mine look like this:

• A new holder for the ribbon where M3 screws fit through. I do not have M2 inserts, so I used M3 ones for the ribbon holder. The original creality holder uses M2 screws/inserts, but they will not hold. This ribbon holder works: https://www.printables.com/model/449608-sleek-sprite-extruder-ribbon-cable-strain-relief

Some Recommendations:

• First prepare the inserts, before disassembling the extruder, and check that everything works as expected.
• I had quite a bit of problems designing the holes/inserting the threaded inserts correctly, this guide might be helpful: https://hackaday.com/2019/02/28/threading-3d-printed-parts-how-to-use-heat-set-inserts/
• You can print the entire model without supports, orientation should be correct.