Skådis headphone mount

This headphone hanger uses a subtly curved design and exported at an overly high resolution for a smoother curve to avoid adding bumps into the headband.

The three holes have a decorative relief for an ifixit screwdriver and can accomodate even the shortest of bits! Design oversight? Nooo..

I added a thin cut into each of the grooves so the slicer adds additional material here to improve the strength of the part.

The unit has three holes with a 20mm gap to accomodate a two, or one hole mounting option.

The divots above and below the holes are for indexing and uses bamboo Q-tips for pegs, cut to length after inserting.

The M3 countersunk bolts used are 14mm long and goes through the entire length of the t-nut.

The unit is mounted to the pegboard with T-Nuts provided by @6d6178 and @SamuelHaberli_587722 for the M3 variant used