AT-5555N II Handles

This model is  a set of handles for use with an Anytone AT-5555N II 10m all mode radio.  They can provide some assistance in handling an unmounted radio, provide a measure of protection for the front panel & knobs, and raise the radio above a flat surface to improve audibility of the bottom mounted speaker and enhance air flow for cooling.   There is also a provision for “prop” sticks to raise the radio front for better display visibility and sound direction.

No need for supports.  I printed using ASA for environmental durability.  This print requires a print bed of at least 300mm to print in one piece.  It could be segmented for printing on a smaller printer, but such a modification is not included. 

With my settings, 0.3mm layers with a 0.6mm nozzle, print time was about 3 hours and used about 120g of material on my XMax3.

Handles are attached with  two M5x10 screws, 4 total.

STEP file & Fusion 360 source included