Bunk bed side desk brackets

My daughter's new small desk is hanging on the side of her bed.

The distance of the opening between the wooden bars is roughly 7cm.

After printing v1 I learned that it would be better to also ‘hook onto’ the top. So I made a v2 that was also a bit simpler. Both only just fit on a Prusa MK3S+ bed.

In the picture you see I also use the v1 brackets, because it would be a waste not to. 

Print instruction

• I used a modifier block at the smallest point and set infill to 25% to make it a bit stronger.
• I printed it in PETG, since presumably PLA will sag in the long term under a constant force. Also PETG probably slides better.
• A brim helps with warping, but since the model only just fits, I could only make v2 fit by rotating and using only a 1.5mm brim.

Cameo

Also in the pictures is my desk side tray.