Covert ZYN Can - Small Box That Holds An Entire ZYN Can!

Please Share Your Makes and Give It A Like! 

I have a friend who loves ZYN, however, he said he doesn't like the fact that the can shows in his pocket all the time, plus with all the other “everyday carry” stuff he has, the ZYN can takes up a good amount of pocket space. So he asked me to design a smaller “can” that could hold an entire ZYN can (15 pouches) that was small enough to fit in the “lighter/coin” pocket on most jeans. So I did exactly that!

It prints very easily, no supports needed. Use whatever filament you want. I made his in PLA and he has used it for months with no issues. 

On note: The lid is a tight fit so I suggest “working it in a bit" by opening and closing it a few times. Start by putting it on without fully closing it, then open and close it more and more. If it's way too tight, try taking 0.10 off the bottom of the lid at a time using the ”cut" tool in your slicer until it fits. I printed mine on a Bambu X1C and it's a perfect fit.