Voron 2.4 XY Cable Chain Bridge - 3 Hole - 19mm Higher

I built my Voron 2.4 very close to specification, but at closer inspection I found that I installed the cable chains the wrong way round (yes, this is possible). This makes the cable chain kink at the top connection and allows the cable chain to create a much more open curve. I wanted to remove this kink and I changed the cable chain around. This resulted in a tight bend on the cable chain as per design. This was too tight for my liking.

I also had problems before where the cable chain rubs against the bridge because of the angle on the bridge. 

The third problem that I wanted to solve was the wires that make contact with the Z belt when the Y axis moves all the way to the back.

With this model I tried to solve these issues.