Desk Deep Clamp on Desk Holder for Large Tumblers

This is a remix of ShaneTalksTech Clamp on Desk Cup Holder.  His didn't fix my desk due to a support bar and my desktop being only 5/8 inches ~15mm thick.  I deepened the the mouth of the clamp and moved thread out so it could clear the bar which is about 34 mm from the edge of my desk.  I also lengthened the end of the bolt shank (no thread) so it would make solid contact with the bottom of my desk.  Because there is no thread on the end of the bolt it may not work with thicker desks, but it's the same thread as his bolt so you could just use that. 

After my print I thought the opening for the cup handle felt a little week, though that could be due to the amount of infill I used.  So I included an additional holder that doesn't have that opening if you like me have a tumbler without a handle.  I haven't printed that so it's untested.

Printer Settings

• PLA

• Nozzle: 210 Bed: 70

• Speed 90

• 5% Gyroid infill 

• Brim Adhesion (May not be needed)

• Tree supports at 65 degrees (this keeps supports from being build on the threads, and held up just fine during printing)

I also added a piece of adhesive backed rubber to the top underside of the clamp for a little more friction.

Have a 24oz Stanley Coffee Mug?  Try this one made just for that.