Corset Belt

This corset belt can be attached in quite a few ways. If you use the 3D printed bell module (or the ribs with bells - ribs 2, 3 and 4 should be printed once normal, once mirrored) or if you use any type of 2.5mm haberdashery rivets (you'll need 84 of them) all away around it's a 73cm waist. In that case, you want to use the front closure. 

Alternatively, you can permanently(ish) attach all the seams with bells or rivets and use the holes in one of the seams to lace a classic textile ribbon through to create a more size-inclusive design. 

Print instructions

Artillery Sidewinder x2 | 0.4mm nozzle
Print without support | flat orientation
concentric top & bottom layer | 90% line infill density
93A TPU Glitter Blue from SmartMaterials3D (93A+ for best result)
65g of filament
8h 32min