CH Products Pro Throttle 50% detent - forward backward throttle

Add a detent to you CH Products Pro Throttle to turn it into a forward backward throttle.

There are 2 versions with different stiffness, pick one depending on the filament used and resistance you want. I printed mine in PETG, TPU 95A was too soft.

No supports needed.

Installation

1. To install turn the throttle upside down and remove the 4 rubber feet with a flat head screw driver or similar (they are glued on with sticky tape).
2. Unscrew the 4 screws under the feet with a phillips screw driver.
3. Unscrew the middle screw that holds the throttle plat in place with a phillips screw driver.
4. Place the new printed part as per the image and screw back in using the same screw that was removed in step 3.
5. Close everything back up.
6. Stick the rubber feet back on.