Tap Blower 4010 duct

***This is tested on a stealthburner with a revo and choatic lab v2 tap. 

***I run sensor less homing, I do not know if this will clear limit switches. Why are you still running switches?

*** use M2x10 self tapping screw to mount the fan and Voron PIF settings in ABS or ASA.

*** no supports needed but supporting the duct doesnt hurt.

used a GDSTIME fan

I wanted to add a secondary fan because SB cooling is pretty weak. There was no way really of add one without a total redesign. Then I saw a 2 unused holes on my chaotic lab v2 TAP after a while I came up with this design.

I did a before and after benchy test using a revo nozzle. I bump the settings unrealistically high just to see what the cooling can do. 

The benchy was printed at 15.42 minutes. I used the same GCode file. 

Left is stock right is with Tap Blower

please leave ⭐ review and rate. 

Buy me a some raman if i helped you out in anyway.

 https://ko-fi.com/3deeznutz

Check out my other designs.

https://cults3d.com/en/users/3DeezNutZ/3d-models

https://www.printables.com/@3DeezNutz_752861/models