Headphone Stand | Headset Desk Holder
ExtrutimJanuary 7, 2025
Description
A multi-part headphone stand to assemble!
The headphone stand has a height of 24cm at the contact surface of the headphones and is therefore suitable for all common headphones / headsets.
| There is a hook on the back to hang up a cable, which is optional and can simply get left out. |
You only need the following screws:
- 4 psc. M3x14-20mm cylinder head screw
- 4 psc. M3x6mm cylinder head screw
The red feet are available in two versions, with and without rubber pad made of flexfilament. |
The model is easy to print, no supports are necessary, bridges are built in at some points and supports are added at the Base piece. Print the model with a layer height of 0.2mm for best performance.
Minimum print bed size: |
Print instructions:
Print all models as aligned with a layer height of 0.2mm. You can print the foot part with the built-in or self-generated supports.
For a good looking result, your filament and the first layer should be well adjusted.
I recommend at least 3 Primeters, 15% infill and you should consider printing the head piece with a brim.
If you want, you can fill the base part with sand or something similar during the print to increase the weight a bit.
| Please leave a like if you enjoy my design. Also feel free to check out my other uploads. :) |
Changelog:
- 11.08.2024 - A screw hole in the "Head" part was not fully extruded. This fault has been fixed.
