Protects your phone and especially the camera bulge in the back against scratches and bumps while allowing the phone to cool properly when charging or in use.
Update 4-10-24: added speaker notch; keeping only the camera bulge ring design going forward.
Print Settings
Rafts:
No
Supports:Â
Yes
Resolution:
0.2 mm
Infill:Â
10%
Filament: any TPU any
Notes:
- Print in TPU in the orientation shown in the screenshot.
- Raise bottom contact distance to 0.4 or deactivate the bottom interface layers to make supports easier to remove.
- Choose classical supports placed everywhere.
- Pick two top support interface layers with a separation of 0.2 mm and rectilinear pattern.
- I chose a bridging pattern angle of 60º and 70% infill/perimeter overlap to get successful bridging atop the supported areas.
- In Prusa Slicer 2.7.3+ make sure you enable the "detect bridging perimeters" section--but not in earlier versions where a bug causes perimeters to be printed outside supports.
Category: Mobile Phone
zzzy
