Magneto X 3DChameleon Mounts and OrcaSlicer Profile

These are the mounts for the 3DChameleon to attach it to the Peopoly Magneto X.

The main 3DChameleon mount uses two M3x10 screws to affix it to the left side of the MagnetoX's top rail.  The 3DChameleon will fit inside the holder and can be secured with a long zip tie using the two top loops.  This mount is derived from willempie25's excellent holder for the Adventurer 5 which can be found here: https://www.printables.com/model/756165-3dchameleon-holder 

The switch is attached using two sided tape to the top right rear of the Y axis.

The electronics are attached to the bottom just in front of the cable mount using two sided tape.  You can use the wire mounts to secure the wires also using the two sided tape.

The profile has the button on the Y axis at 400 with a holding position of Y397.  Adjust the switch to trigger at exactly 399.5 so you don't trigger the printer's estop because it went too far. It is very sensitive to that. 

Print with PLA or PETG, with 4 shells and 45% infill for all parts.

The original source files for these models are on Tinkercad here: https://www.tinkercad.com/things/2WR7WWLvJap-3dchameleonmagnetoxmounts