Nutstein Parallelanschlag Bosch GTS 10 XC

This model is a hammerhead nut specific for the parallel guide of the Bosch GTS 10 XC table saw.

You can use it to mount your specific attachments, like

• feather boards
• router table parallel guides for an integrated router
• or whatever you can imagine

You'll need a 6mm nut acc. to DIN 562 (low profile square nut) to be printed in.

I ordered this ones from Amazon: https://amzn.eu/d/6zvtiov

Pause after 3.8mm height, insert the nut and continue the print.

I added a adapted model with thin layer above the nut in order to improve print quality (see 3rd picture that shows the cross section).

Just insert a Screw from the bottom side in order to break the thin layer.

Evtl. you need to use a sharp knife resp. nippers in order to clean the hole.