Wago 221-2411 Connector for 2/4/6/8

Hi,

a friend was in need to connect some wires for a project of his. I found the model of ‘Jemand/Joschas’ and it fitted his needs. We just needed a version for 6 wago 221-2411 clips in one piece and a base size of 52 mm x 39 mm for glueing it down. So I made this remix. 
It works well in his project. I than added versions for 2/4/6/8 clips to this model to give it more usecases. There are versions with/without flaps and screw holes (3,30 mm).

I printed a few in PLA+ as also in PETG.  The fit is good, no problems so far. Nothing special for the print parameters. Mine were:

• layer height: 0,3 mm
• walls: 2
• infill: 15% cubic
• 3 TOP & 3 BOT layers

The holes are designed as 3,30 mm, on my prints they turned out slightly smaller than 3 mm.
So depending on your printer calibration & the screws you wanna use you have to drill them a bit up.

Happy printing!