Foot Reflexology

Disclaimer:  This model is experimental and for entertainment only, it does not represent a medical solution. Any discomfort or pain in your body should first be consulted with a medical specialist.

Instructions: Insert the required pressure points into the footbed like a Lego (the areas that do not require pressure should be completed with the flat-surfaced pieces), rest your bare foot on the surface and apply your body weight to the insole for a few minutes making light circular pressing movements as needed. 

DO NOT APPLY TOO MUCH PRESSURE OR USE FOR TOO LONG!

YOU COULD GET INJURED!

To adapt it to the size of your foot, you need to measure your foot template on a piece of paper and scale the 3d print in both sizes - length and width - of the model.

Foot: Left  (If more than 10 people ask for it, I will include the right foot)

Supports: NO

Material:  ABS, PETG or any weight- and water-resistant material (must be washable to prevent fungus)

Layer Height: 0.2 (with variable height to 0.08 on the pressure balls) 

Wall Loops: 3

3MF prepared and printed for: X1C