Cable Holder

This print will allow you to manage cables that need to be routed across a ceiling or wall. I needed this to run cable in my garage and I did not want to crawl through the attic or chase wires through walls. With a little bit of Velcro your cables will stay put and in place, Velcro not needed but it is a nice touch!

Version 4 will allow a Ethernet Patch cable to pass through it without needed to re-terminate the cable ends. 

Version 3 will allow thinner cables, like some HDMI cables to pass through after the cable holder is mounted.

Scale the print to make smaller or bigger versions for your needs!  

Use can even use it on the back of entertainment centers or desks to manage those cables also.

Mounted with general purpose wood screws into studs.

**************************************************************************************************

A single Version 4 will print in approximately 35Mins on a Prusa MK3S.

Slicer: PrusaSlicer

Print Settings: 0.30mm Draft

Material: Inland Red and Black PLA

Also works well for those “left over” spools of material, simple to load more filament to finish up the print. :)