April 12, 2024
Description
This is a Makita DC18RA 18v Battery Charger Mount that attaches to the SKÅDIS pegboard with printed M2.5 T-Nuts from 6d6178. (See their collection of T-Nut mounted parts below.)
The result is parts that hold the charger firmly on the board and allows it to easily slide up and out off the pegs if needed. I've designed the parts to be able to lie flat on the print bed without any supports (really) for a quick clean print. There are a couple of integrated minimal supports for the Right side mount which easily snap off after printing.
- 1 x SKÅDIS Makita Battery Charger Mount (these printed parts)
- 4 x printed SKÅDIS T-Nuts (from 6d6178)
- 4 x M2.5 hex nuts (to drop into the printed T-nuts listed above)
- 4 x M2.5 screws
| Read more about the Skadis T-Nuts Mounting System and check out the Skadis T-Nuts Collection for more Skadis accessories that use T-Nuts. |
License:
Creative Commons — Attribution — Noncommercial — Share Alike
9
A4O Labs
