October 31, 2021
Description
This is my attempt to create a Mario wall type Amiibo stand.
It prints easy without any supports. Use 0.2mm layer height and 7% infill with a triangular infill and 3 walls to make it beefy.
The brick joint area needs to be printed four times and should be black or any other dark color you like. It will be glued into the cube.
Print the block in terracotta or some other earth kind color and the grid in black. It will fit right in and just needs a little glue. If you don´t want to print the small joint grids, when you can use a sharpie to color the gap between the bricks to get the effect.
As always the FreeCAD source file is included.
Happy Printing
Printer:
TronXY X5
Rafts:
No
No
Resolution:
0.2
7%
Filament: Noyes PLA Terracotta, Black
Notes:
7% of infill is far enough if you use some triangular infill and 3 walls.
There is no support needed. Any printer should be able to bridge the brick gap.The black joint element needs to be glued in.
Category: SculpturesLicense:
Creative Commons — Attribution — Noncommercial — Share Alike
geit_de
