As usual the model part consist a big parts but the very small also so pay attention to the description and attached pictures. As usual be extremely careful during the assembly itself and work slowly and cautiously. If you manage to damage or break some part despite being extra careful you should "weld" it with a soldering gun rather than gluing it with super glue.
For today I prepared to you the front mudguard, seat, exhaust pipes and some small parts. Before each glue try to assembly all parts together and make sure that all parts fit.
If you will need more pictures for better understanding, you can see here:
reflecting_glass_rubber1 - 1 pcs, black PLA, 100% infill, 0.15 layer.
reflecting_glass_rubber2 - 1 pcs, black PLA, 100% infill, 0.15 layer.
Assembly instruction:
If you printreflecting_glass.stl from transparent red you will need a piece of aluminum foil. If you print it from crystal clear PLA you will need a piece of red foil (for example from some candy). I chose the second option.
Insert the reflecting_glass_rubber1 into rear mudguard. It is little bit tricky so be patient. Fix it on the place by super glue.
glue the piece of the foil
glue the reflecting_glass into the reflecting_glass_rubber2.
This subassembly glue on its place from outside of the fender.
Glue together shifting_lever and shifting_lever_rubber.
Glue (optionally NOT!) the shifting_lever_axle into left engine cover from outside. See on the picture below.
The left engine cover fix on the engine by 4 pcs of M2.5-16 + 1 piece of the M2.5-10 screw. I recommend to use standard DIN 84 for this screws. It looks better.
Slide the lever on the axle from outside. Take careful on the correct position.
From bottom side screw into the lever M2-10 screw. After tighten the lever should not move on the axle.
OPTIONALLY
DO NOT GLUE the shifting_lever_axle into cover!
Glue together the starter_spring and the starter.
The subassembly install into the starter_holder.
from rear side slide on the starter the starter_fixation and weld it by soldering gun together with the starter to the one piece.
Make sure that the shifting_lever_axle and gear_shift_axle slide into each other and turn easily. All assembly must be easily movable without bit friction.
Screw the starter assembly with the shifting_lever_axle and gear_shift_axle into the left engine carter by 3 pcs on the M1.6-5 screws. Before that, turn the spring 1-2 turns counter-clockwise to tension the spring and hang it in the holder in the left engine crankcase.
From right side slide the clutch_cam on the gear_shift_axle and fix it by M1.2-8 screw.
The left engine cover fix on the engine by 4 pcs of M2.5-16 + 1 piece of the M2.5-10 screw. I recommend to use standard DIN 84 for this screws. It looks better.
Slide the lever on the axle from outside. Take careful on the correct position.
From bottom side screw into the lever M2-10 screw. After tighten the lever should not move on the axle.
jawarmaniak
