April 15, 2024
Description
AUW: 45.5g
Battery: 150mah 1s
Servo: 2x 1.7g rotary servo
Receiver: RX42
Tailboom: 3mmx2mmx400mm carbon tube
Wing spars: 6x 1mmx400mm carbon rod
Instructions coming soon. It should be possible to reverse engineer from the photos if you're experienced. Nose cone should be printed vase mode with 0 top/bottom. Nose and wing panels are LW-PLA, Vase mode, 0 top, 2 bottom. Wing pieces are printed on the trailing edge on the bed. You'll have to trim out the sacrificial support areas with a sharp exacto blade. Cover with tissue paper of your choice, but be wary of warping as the trailing edge is quite thin.
License:
Creative Commons — Attribution
8
Impulse Ungineering
