October 24, 2025
Description
I designed the mount to print in two parts.
Used the ball joint by Arthur Zopfe on Thingiverse, but as the nut is smaller then the ball I had to design it in place with support. It's easy to remove, only the top surface of the nut could be a bit cleaner.
Be sure to block the support above 10mm, not to get it into the thread.
To stick the Magsafe into the top part I used double-sided tape (the normal white one), to stick all together on the dashboard I took 3M VHB.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
8
IkarusIBK
