Case for Adafruit Animated Eyes Bonnet for Raspberry Pi W/ US-100

A case for Adafruit's Animated Eyes Bonnet for Raspberry Pi using the US-100. (No more level shifters.) The case will mount either a Pi Zero or a full sized Raspberry Pi on the front inside face or inside bottom of the case. The US-100 mounts through the front of the case. The idea is to place the box in a dark place and uses the sensor to wake the effect up a programmable distance.

The fourth generation of the case for Adafruit's Animated Eyes Bonnet for Raspberry Pi provides for an interchangeable solution to protect the TFT's. The provided example cover works with any 40MM round cover. This includes AdaFruit's glass lens (https://www.adafruit.com/product/3853) and plastic lens (https://www.adafruit.com/product/3917.) It is a good idea to mask the TFT with tape or dark construction paper to prevent light leakage around the edges.

The original design that used the HC-SRO4 can be found at:

https://www.thingiverse.com/thing:3177147 or https://www.prusaprinters.org/prints/8493-case-for-adafruit-animated-eyes-bonnet-for-raspber

The design using the HC-SR501 can be found at:

https://www.thingiverse.com/thing:3574356 or https://www.prusaprinters.org/prints/8493-case-for-adafruit-animated-eyes-bonnet-for-raspber

Blank cover https://www.thingiverse.com/thing:3552052

Single track https://www.thingiverse.com/thing:3552054 or https://www.prusaprinters.org/prints/8529-cover-for-aaeb-w-test-stand-single-channel

Duel track https://www.thingiverse.com/thing:3552060 or https://www.prusaprinters.org/prints/8528-cover-for-aaeb-w-test-stand-dule-channel

Single track center line https://www.thingiverse.com/thing:3578016 or https://www.prusaprinters.org/prints/8530-cover-or-base-for-aaeb-using-a-single-channel-on-c

Speaker Cover https://www.thingiverse.com/thing:3612211 or https://www.prusaprinters.org/prints/8550-aaeb-base-for-top-mount-speaker

Print instructions

Unassociated tags: Adafruit Eye Bonnet, Eyes Bonnet
Category: Electronics