Remix of Squash ball feet for Prusa Mini. All brackets bolt into aluminum extrusions and support the electronic's box.
Highlights:
- Massive Noise Reduction
- Improved Stability (Lifting the magnetic sheet won't tilt the printer)
- 6 Support Points without increasing operational footprint.
This is inspired in https://www.thingiverse.com/thing:4752965 from jrjonescan, I love the weight distribution and support points choice. But it was too bulky, so I recreated the low profile from Vektor.
- Print 3x Single Foot (If you are going to use the Spool holder print only 2x)
- 1x each other model
You will need:
- 6x Squash Balls (double yellow dot)
- 5x M6 x 12mm Bolts
- 5x M6 T-Nuts
- *If using the spool holder setup, you will also need:
- 2x 608 bearings. Alternatively, you can reuse the originals from the mini Spool Holder.
- 1x of the Original Prusa Mini Foam Feet (The spool holder includes a slot)
Spool Holder:
This is a remix of the popular Spool Holder from Max with the Squash Ball foot + the "Filler" Filament Roller.
Print instructions
- .25 layer
- 3+ perimeters
- ±30% infill
- Minimal Support ( set overhang threshold to 5º, so supports is added only to critical areas)
- PLA / PETG
erickson85
