This is a set of simple wall brackets for hanging boards or similar to a wall using nails or screws.
You can chose from the following options:
- Nail or screw bracket
- 6mm and 8mm height
- clean model that will require support or models with a designed sacrifical layer that prints with bridging instead of support, but needs to be trimmed away after printing
- Extra: Spacers that can be glued to the lower part of a board to make it hang parallel to the wall
Printing
- use 3 or more perimeters for additional strength
- orient them flat on the print bed
- enable support for the clean models
BitBender
